Following the introduction of the Kverneland 150B (shear bolt) and 150S (leaf spring auto reset) lightweight reversible ploughs, the company has extended its latest plough range to include hydraulic vari-width on both types.
Called the 150 Variomat, the new version brings hydraulic furrow width adjustment from 30-50cm (12-20in), for those who frequently adjust furrow widths to get the best output from available tractor horsepower and soil conditions.
“A simple shift from 12in to 18in furrow widths will yield a 30% increase in working width,” explains Kverneland plough specialist Adam Burt.
“Fuel consumption is not proportional, which brings greater efficiency to ploughing. And a wider furrow width generates more clearance too, for those dealing with stripped or chopped straw.”
The 150 Variomat plough comes in three- four- and five-furrow versions, with a 150mm x 150mm induction heat-treated main frame used on all models. Despite the bigger frame than the non-Variomat models, the plough doesn’t need vast amounts of horsepower to be handled, nor lifted. Kverneland says the 150 Variomat is suitable for tractors up to a maximum of 150hp.
The plough gets a one-piece headstock design that keeps the implement as close to the tractor as possible to reduce lift requirement. The main shaft is a 110mm diameter, heat-treated design, engineered for maximum strength, while cross shaft options include Cat II, Cat III and quick coupler types.
A 70/75cm underbeam clearance is used for the 150 S Variomat, while the B Variomat is 80cm. Both share an 85/100cm interbody clearance for optimum performance in various soil and surface conditions. Front furrow width adjustment can be either the standard turnbuckle or optional hydraulic adjustment.
Kverneland’s 130-year expertise in plough manufacture has enabled the factory to forge tailor-made boron steel and apply unequal heat treatment technology to the entire plough to create a lightweight but strong fabrication.